#Accurate 5 load data pdf#
#Accurate 5 load data manual#

224' never exceed the maximum load SPECIAL NOTES: Extremely sensitive caliber. 2015 is a popular choice for first-class performance in benchrest calibers and is also recommended for use in large bore straight wall cartridges (45-70, 458 Win Mag). Start with this beginning load and work up to your maximum charge, all the while searching for the most accurate reduced load. Additional safety information can be found HERE. вЂќ * = Most accurate load tested 9 7 % 9 3 % 1 0 7 % 9 6 % 9 8 % 9 3 Accuracy Load Viht N140 37. 2 Nitro 100, Accurate 89 Solo 1500, Scot 176 Reloder 12, Alliant 3 N310, Vihtavuori 90 True Blue, Ramshot 177 N135, Vihtavuori 4 Titewad, Hodgdon 91 N-1020, Norma 178 IMR-4064, IMR 5. ACCURATE 2230-S Data powder: (ca 4% faster than the standard A-2230). mid-range target loads, in cartridges ranging Marvin Stuart In no event shall Nosler, Inc. For a traditional black-powder load in the. Coated Bullet Reloading Information (The Blue Bullets LLC) Reloading coated bullets is slightly different than loading a jacketed or lead bullet. This guide is not intended to be a reloading textbook, but rather a list of recommended loads for Accurate powders. Reloading Reference Data & Education ACCURATE 2230-S Data powder: (ca 4% faster than the standard A-2230). Begin at the MINIMUM start load and increase only in increments of 0. It is quite another thing to work up loads for a mixed bag of 9mm hand-guns using вЂњrange brass. all of which go to different friction and pressure profiles. 180вЂќ Alliant PowderВ® ReloderВ® 7 N/A N/A 40. Cartridge Construction ACCURATE 2230-S Data powder: (ca 4% faster than the standard A-2230).

#Accurate 5 load data pdf#

When I first started chronographing handloads back in '75 or so, it was a different story, but now they are cheap and much better.Accurate load data pdf 40. Chronographs are cheap now days and every serious handloader should have one. Also shoot your loads over a chronograph and when you get to factory ballistics let it go at that. 380 I would start low and work up in smaller increments, say 1/10 grain. 380 pistols are small guns and not designed for containing high pressures. Another element of the equation is that most. Increasing the charge from 3.5 to 4 grains re[resents a 14% increase and could be a little dangerous. This is a small capacity case and small increases in powder charges have a disproportionate affect on pressures.

380, it is a little tricky to load to the max and still stay within the safe range. 5gr will this increase the amount of unburnt powder if there is any in the first place or will a little more will help with a more complete combustion?

my question is, if there is unburnt powder and i add. i guess i am close so now i'm thinking 4.0 gr is the next increment.

the new load from Western Powder for this bullet with No.5 is '100 (P) BERRY RNHB 4.3 - 5.1'. i just looked at the load powder from Accurate and they now list Berry's bullets when before i could not find anything for plated so i just went with LRN loads. percentage wise that was a big differential so i settled on 3.5gr. When i first researched load data (western powder included) the numbers were all over the place and it seemed much more difficult to come up with a starting load that i felt comfortable with being new to reloading.minimums from 3.0 to 4.3 and some higher. That is why I suggested that the OPer start a little low and work up his load.ДҐof7 wrote:That is why I suggested that the OPer start a little low and work up his load. That would be distinctly slower.ДIFFERENT BURN RATE CHARTS will show differences in the position of the powders that they cover.that is nothing new.ДЄ burn rate chart is only a reference source to use as a rough guide for a handloader in the event that he has no access to tested data for the powder/cartridge combination that he intends to use, it is NOT an absolute authority of burn rates since burn rates can change slightly when powders are used in different cartridges.

#Accurate 5 load data manual#

THE NEW HODGDON MANUAL shows AA5 to be ten notches down the burning rate chart slower than UNIQUE. Here in a burn rate chart that shows AA5 to be a little faster in burn rate than Unique though. You might want to start a little lower and work up in 1/10 gr. bullet and it worked fine, so I would think that AA5 would be fine also.